Adding Temperature Data From The Hydrophones To The System - Marport M6 Mx Service Manual

Adding Temperature Data from the Hydrophones to the System

You can add the hydrophone to the receiver as a sensor in order to display in Scala/Scala2 the
temperature of the water surface.
Before you begin
Important: In order to receive temperature data, make sure the hydrophone is connected
to an NTC input on the receivers or is connected using an NMEA converter junction box. See
Connecting the Hydrophone to the Receiver
Procedure
1. From Scala/Scala2, click Menu
2.
Click Menu
3.
Right-click the IP address of the receiver at the bottom of the page, then click
Configure Receiver.
4. From the left side of the receiver page, click Sensors.
5. Under Add Sensor Product:
a) Select Hydrophone in the Product Category menu.
b) In the Product Name menu, select NMEA temperature if using an NMEA converter junction
box, or NTC temperature if the hydrophone is connected to an NTC input.
c) In Hydrophone Location, select the number of the receiver's port on which the hydrophone
is connected.
d) Click Add Sensor.
Results
The water temperature is displayed in Scala/Scala2, in the control panels, under
Data / Mx.
on page 49 for guidelines.
> Expert Mode and enter the password copernic.
> Receivers.
M6 - Mx computer System | V2 | Installation
Sensors
| 50