Installing A New Ethernet Cable - Marport M6 Mx Service Manual

3. In the network list, click Ethernet, then:
a) In Configure IPv4 menu select Manually.
b) In IP Address, enter 192.168.10.165.
c) In Router, enter 192.168.10.1.
4. Click Apply.

Installing a New Ethernet Cable

If the Ethernet cables that connect the Mx computer to the receivers is too short, you can replace it
by a longer Ethernet cable.
The new Ethernet cable must have the following specifications:
• Category: cat. 5e minimum
• Length: 100 meters maximum
• Shielding: U/FTP
When replacing the cable, you need to install an Ethernet connector on the cable end that is
connected to the receiver. The Ethernet connector kit is included in the product package.
To know how to install the Ethernet connector to the new cable, refer to the assembly instructions
included with the Ethernet connector kit.
M6 - Mx computer System | V2 | Installation
| 38