Removing M6 Protection - Marport PRO M6 Service Manual

6. Click Identify to see which module corresponds to which receiver.
The LEDs on the corresponding receiver blink green several times.
From version 06.00.05 and later of Mx receivers, you need to upload a license file into
your system to make it fully operational.
For this task, you need two license files (*.zob). Refer to Marport sales offices to get
them.
Note: This procedure applies for receivers version 06.00.05 and above.
By default, Mx systems are limited to a specific number of sensors: 12 PRP sensors (e.g.
catch, spread, trawl speed...) and 1 NBTE sensor (Explorer sensors). You need a license
file to disable this limitation and to be able to add more sensors. The license file also
allows you to add a TE SC sensor to the system.
1. In Firefox web browser, enter your receiver IP address to access the receiver
settings on the system web page.
You can see that the system is on the default (DEF) limited configuration (12 PRP
sensors and 1 NBTE sensor).
2. From the tree view of the system on the left side of the page, click Settings.
3. In ZOB Upgrade, click Browse and select one of the two license files.

Removing M6 Protection

M6 PRO | V7 | Installation
85