Marport M6 Mx Service Manual page 34

Note: Make sure that the cables from the junction boxes are long enough to reach the
receivers.
5. Install the Mac and Mx computer in a dry and ventilated area, without dust, in the wheelhouse.
6. Install the monitor(s).
7. Install the loudspeakers, if applicable.
8. Connect the Mac, Mx computer and receivers according to
9. You can switch on the computer.
10. Configure the networks and the receivers.
11. Connect the hydrophone cables to the junction boxes and connect the junction boxes to the
hydrophone connectors on the receivers. Refer to Hydrophone installation manual for detailed
guidelines.
12. When adding sensors to the system, refer to the
allocating frequencies.
M6 - Mx computer System | V2 | Installation
System Cabling
Frequency Plan on page 72 to help you
on page 34.
| 33