Marport M6 Mx Service Manual page 31

5. Command lines appear: type ./S (uppercase letter), then press Tab (
Note: To make sure you plugged in the correct USB key, check it is written Mx 2019-09
above the last line.
The last line should show: user@debian:~$ ./SetMxProcessorDisk.sh
6. Press Enter and wait for the installation to complete.
The process takes approximately 30 minutes. When the system installation is complete, the
start screen is displayed.
Trouble: If you pressed a key and left the start screen, you can still proceed as described
below.
7. Press
to switch off the Mx computer.
8. Remove the system key.
9. Press
again to switch on the Mx computer.
10. Place caps on the Ethernet port(s) according to the formatted system.
M6 - Mx computer System | V2 | Installation
) key.
| 30