Powering The Mx Computer; Changing Mx Computer Ip Address - Marport M6 Mx Service Manual

Powering the Mx computer

About this task
Important: Only use recommended power supply MEAN WELL HEP-150-24 A. Marport
cannot not be held responsible for dysfunction of the system if recommended equipment is
not used.
Procedure
1. Connect the power cable to the Mx computer.
2. Connect MEAN WELL power supply to a power socket.
3.
Press on the Mx computer to switch it on.

Changing Mx computer IP Address

You need to change the IP address of the Mx computer if the Mac computer is connected to another
network that has the same subnet as the Mx computer.
About this task
Note: If the Mac computer is connected to another network (WiFi, wired), check the IP
address of this network. If it has the same subnet as the Mx computer (192.168.10.XXX), you
need to put a different subnet to the Mx computer, such as 192.168.11.170.
Procedure
1. Open Mosa2 and click the receiver icon on the discovery page.
2.
Click in Receiver information.
3. Change the IP Address to 192.168.11.170 and the Gateway adress to 192.168.11.1.
M6 - Mx computer System | V2 | Installation
| 36