Configuring the Receivers
You need to update both Mx receivers to make them compliant with an M6 system.
About this task
In this procedure, the Mx receivers are called receiver 1 and receiver 2. It is up to you to choose
which is 1 or 2.
Updating the Mx Receivers
Procedure
1. Open Scala/Scala2.
2. Connect receiver 1 to the Mx computer.
3. Wait between 3 seconds and 3 minutes and click OK to the following message:
4. Wait for the receiver update to be complete.
Note: You may have this error message when the receiver disconnects itself. Click OK.
When the update is complete, there is a green check next to H1-H2-H3 Module.
M6 - Mx computer System | V2 | Installation
| 39