Testing The Lift - Zepro Z 150-135 Installation Instruction

Testing and verification of the tail lift.
Carried out in accordance with the installation in-
struction and delivery check list.
Check that the tail lift chosen corresponds to the
vehicle and to its foreseen use.
Static loading test
To be carried out when installation is complete.
Deformation
Position the tail lift with the platform horizontal about
half way between the ground and the vehicle floor.
Measure the distances A,B,C,D as shown in the
diagram. Place a test load on the platform according
to the table (for the corresponding tail lift model and
loading capacity). Remove the load from the
platform. Repeat the measurements of A,B,C,D and
check that there is no permanent deformation to the
tail lift or its brackets.
Deflection
Place a test load on the platform according to the
table (for the corresponding tail lift model and loading
capacity). The tail lift should be in the same level and
angle as floor. Leave the test load on the platform for
15 minutes. Check that the platform´s deflection is
not more than 15mm vertically (point A and D) and
that it is not more than 2º in angular deflection (point
b and C), in relation to floor level.
C
B
Deformation
12. Load testing the tail lift
D
A
Max 2º
Static loading (Test load 1,25 x tail lift loading
capacity). For tail lifts with load centre of 600 mm
Capacity
450 kg (450 kg) 675 mm
500 kg
700 kg
750 kg
1000 kg
1500 kg
2000 kg
2500 kg
Static loading (Test load 1,25 x tail lift loading
capacity). For tail lifts with load centre of 750 mm
Capacity Load 1000 kg
1000 kg
1500 kg
2000 kg
2500 kg
D
C
B
Deflection
36
Load 500 kg Load 1000 kg
Distance out in platform (L)
750 mm
1050 mm
1125 mm
1450 mm 750 mm
2250 mm 1125 mm
- 1550 mm
- 1875 mm
Load 1500 kg
Distance out in platform (L)
940 mm
1410 mm 940 mm
1875 mm 1250 mm
2340 mm 1560 mm
A
Max 15 mm
-
-
-
-
-