Zepro Z 150-135 Installation Instruction page 31

Adjustment of tilt down angle.
NB. To obtain the correct function after adjustment, it
is necessary to first follow the procedure on previous
page which describes the adjustment of the 90º tilt
angle up against the body.
Run the lift up so that the lift is at the floor level, see
pict 20.
Loosen the ring's lock screw (2). Screw the ring out
in the direction of the platform (3). See pict 21.
Tilt down the platform to maximum 10 degrees under
horizontal.
As per pict 20.
Adjust the ring to the top of the cylinder (4).
Tighten the lock screw in the ring (5). See pict 22.
Test run all functions.
Pict. 20
8. Installation, continued
Adjustable collar
Lock screw
Lock nut
31
Pict. 21
2
Pict. 22
5
4
Ring
3