Zepro Z 150-135 Installation Instruction page 22

Identification Code 1
00–99
P
(Program
configuration)
J
01–99
Software version
1.-7 (Fixed light)
1-7
Active control device
while operating
1-7 (Flashing)
The control device
that the control sys-
tem is locked for for
a while after opera-
tion completed.
1-7
C
Sensor indication
Segment
Example of sequence of information codes:
Program configuration: 01, Voltage detected: 12V, Software version: 02
7. Connection unit
Information codes
Code Code
2 3
Cancelled configuration
-
Dividers
12/24 Number of volts detected
Version number
Fixed light (1-7) displays active control
device during operation.
Segments B, C, E or X are illuminated de-
Segment
pending on which button is pressed
B, C, E
or X.
Control device the control system is locked
for.
This primarily applies to radio and coil con-
trol devices as other control devices have
such a short locking period that there is no
time to see the indication.
The number will stop flashing when one of
the current control device's buttons are pressed.
If the control card has been without voltage
and receives the voltage again when the CS
(cabin switch) is switched on, "7" will flash on
the display and the control card is locked until
the Off/On on the CS is operated.
1-6 segments indicate sensors.
On - signal in.
Off -no signal in.
(See electrical and hydraulics diagrams
for information about the location of the
sensors).
Information
22
Other
In
C
B
X
E
Out
Di2
Di3
Di1
Di4
Di6
Di5