Router Objects; Access List - Fortinet FortiGate FortiGate-5001 Administration Manual
Fortigate 5000 series
Hide thumbs
Also See for FortiGate FortiGate-5001:
- Quick start manual (2 pages) ,
- Introduction manual (77 pages) ,
- Quick manual (37 pages)
Table of Contents
Advertisement
Router objects
Router objects
Access list
164
To configure an offset list
1
Go to Router > RIP > Offset List.
2
Select Create New to add a new offset list or select the edit icon beside an existing
offset list to edit that offset list.
3
Set Direction to In or Out.
4
Enter the offset number.
5
Select the interface to match for this offset list.
6
Check or clear the Enable check box to enable or disable this offset list.
7
Select OK.
Router objects are a set of tools used by routing protocols and features.
Access lists are filters used by FortiGate routing features.
Each rule in an access list consists of a prefix (IP address and netmask), the action to
take for this prefix (permit or deny), and whether to match the prefix exactly or to
match the prefix and any more specific prefix.
The FortiGate unit attempts to match a packet against the rules in an access list
starting at the top of the list. If it finds a match for the prefix it takes the action specified
for that prefix. If no match is found the default action is deny.
For an access list to take effect it must be called by another FortiGate routing feature
such as RIP or OSPF.
Figure 72: Access list
Create New
Name
Action
Prefix
Delete, Add
access-list entry,
and Edit icons
Add a new access list name. An access list and a prefix list cannot have
the same name.
The access list name.
The action to take for the prefix in an access list entry.
The prefix in an access list entry.
Delete, add, or edit an access list.
01-28008-0013-20050204
Router
Fortinet Inc.
Advertisement
Table of Contents
