Switching Back To The Default Firmware Image - Fortinet FortiGate FortiGate-5001 Administration Manual
Fortigate 5000 series
Hide thumbs
Also See for FortiGate FortiGate-5001:
- Quick start manual (2 pages) ,
- Introduction manual (77 pages) ,
- Quick manual (37 pages)
Table of Contents
Advertisement
System Status
FortiGate-5000 series Administration Guide
2
Enter the following command to restart the FortiGate unit:
execute reboot
As the FortiGate units starts, a series of system startup messages are displayed.
When the following message appears:
Press any key to enter configuration menu.....
......
3
Immediately press any key to interrupt the system startup.
Note: You have only 3 seconds to press any key. If you do not press a key soon enough, the
FortiGate unit reboots and you must log in and repeat the
If you successfully interrupt the startup process, the following message appears:
[G]:
Get firmware image from TFTP server.
[F]:
Format boot device.
[B]:
Boot with backup firmware and set as default.
[Q]:
Quit menu and continue to boot with default firmware.
[H]:
Display this list of options.
Enter G,F,B,Q,or H:
4
Type B to load the backup firmware image.
The FortiGate unit loads the backup firmware image and restarts. When the FortiGate
unit restarts, it is running the backup firmware version and the configuration is set to
factory default.
Switching back to the default firmware image
Use this procedure to switch the FortiGate unit to operating with the backup firmware
image that had been running as the default firmware image. When you switch to this
backup firmware image, the configuration saved with this firmware image is restored.
To switch back to the default firmware image
1
Connect to the CLI using the null-modem cable and FortiGate console port.
2
Enter the following command to restart the FortiGate unit:
execute reboot
As the FortiGate units starts, a series of system startup messages are displayed.
When the following message appears:
Press any key to enter configuration menu.....
......
3
Immediately press any key to interrupt the system startup.
Note: You have only 3 seconds to press any key. If you do not press a key soon enough, the
FortiGate unit reboots and you must log in and repeat the
01-28008-0013-20050204
Changing the FortiGate firmware
execute reboot
command.
execute reboot
command.
53
Advertisement
Table of Contents
