Networks Options; Interface List - Fortinet FortiGate FortiGate-5001 Administration Manual
Fortigate 5000 series
Hide thumbs
Also See for FortiGate FortiGate-5001:
- Quick start manual (2 pages) ,
- Introduction manual (77 pages) ,
- Quick manual (37 pages)
Table of Contents
Advertisement
Router
Networks options
Interface list
FortiGate-5000 series Administration Guide
Figure 65: RIP Networks configuration
To configure a RIP network definition
1
Go to Router > RIP > Networks.
2
Select Create New to add a new RIP network definition or select the Edit icon to edit
an existing RIP network definition.
3
Enter the IP address and netmask for the network.
4
Select OK.
Configure RIP version 2 authentication, RIP version send and receive for the specified
interface, and configure and enable split horizon.
Authentication is only available for RIP version 2 packets sent and received by an
interface. Set authentication to None if Send Version or Receive Version are set to 1
or 1 2.
Figure 66: RIP interface list
Create New
Interface
Send Version
Receive Version
Split-Horizon
Authentication
Delete and Edit
icons
Add a new RIP interface.
The FortiGate interface name.
The RIP send version for this interface.
The RIP receive version for this interface.
The split horizon type.
The authentication type.
Delete or edit a RIP interface definition.
01-28008-0013-20050204
RIP
159
Advertisement
Table of Contents
