Fortinet FortiGate FortiGate-5001 Administration Manual page 103

System Config
FortiGate-5000 series Administration Guide
You can manage individual cluster units by using SSH to connect to the CLI of the
cluster. From the CLI you can use the execute ha manage command to connect to
the CLI of each unit in the cluster. You can also manage individual cluster units by
using a null-modem cable to connect to the primary cluster unit. From there you can
also use the execute ha manage command to connect to the CLI of each unit in the
cluster. See "To manage individual cluster units" on page 105
• To view the status of each cluster member
• To view and manage logs for individual cluster units
• To monitor cluster units for failover
• To manage individual cluster units
To view the status of each cluster member
1 Connect to the cluster and log into the web-based manager.
2 Go to System > Config > HA.
3 Select Cluster Members.
A list of cluster members appears. The list includes the cluster ID of each cluster
member as well as status information for each cluster member.
Figure 38: Example cluster members list (active-active cluster)
Refresh every
Go
Back to HA
configuration page
Cluster ID
Status
Up Time
Monitor
Select to control how often the web-based manager updates the system
status display.
Select to set the selected refresh interval.
Close the cluster members list and return to the HA configuration page.
Use the cluster ID to identify each FortiGate unit in the cluster. The
cluster ID matches the FortiGate unit serial number.
Indicates the status of each cluster unit. A green check mark indicates
that the cluster unit is operating normally. A red X indicates that the
cluster unit cannot communicate with the primary unit.
The time in days, hours, minutes, and seconds since the cluster unit was
last started.
Displays system status information for each cluster unit.
01-28008-0013-20050204
HA
for more information.
103