Fortigate Ipv6 Support - Fortinet FortiGate FortiGate-5001 Administration Manual

FortiGate IPv6 support

FortiGate IPv6 support
78
To add firewall policies for VLAN subinterfaces
Once you have added VLAN subinterfaces you can add firewall policies for
connections between VLAN subinterfaces or from a VLAN subinterface to a physical
interface.
1 Go to Firewall > Address.
2 Select Create New to add firewall addresses that match the source and destination IP
addresses of VLAN packets.
See "Address" on page
3 Go to Firewall > Policy.
4 Add firewall policies as required.
You can assign both an IPv4 and an IPv6 address to any interface on a FortiGate unit.
The interface functions as two interfaces, one for IPv4-addressed packets and
another for IPv6-addressed packets.
FortiGate units support static routing, periodic router advertisements, and tunneling of
IPv6-addressed traffic over an IPv4-addressed network. All of these features must be
configured through the Command Line Interface (CLI). See the FortiGate CLI
Reference Guide for information on the following commands:
Table 2: IPv6 CLI commands
Feature
Interface configuration, including periodic
router advertisements
Static routing
IPv6 tunneling
209.
01-28008-0013-20050204
CLI Command
config system interface
See the keywords beginning with "ip6".
config ip6-prefix-list
config router static6
config system ipv6_tunnel
System Network
Fortinet Inc.