Switching To The Backup Firmware Image - Fortinet FortiGate FortiGate-5001 Administration Manual
Fortigate 5000 series
Hide thumbs
Also See for FortiGate FortiGate-5001:
- Quick start manual (2 pages) ,
- Introduction manual (77 pages) ,
- Quick manual (37 pages)
Table of Contents
Advertisement
Changing the FortiGate firmware
10
52
If you successfully interrupt the startup process, the following message appears:
[G]:
Get firmware image from TFTP server.
[F]:
Format boot device.
[B]:
Boot with backup firmware and set as default.
[Q]:
Quit menu and continue to boot with default firmware.
[H]:
Display this list of options.
Enter G,F,B,Q,or H:
7
Type G to get the new firmware image from the TFTP server.
The following message appears:
Enter TFTP server address [192.168.1.168]:
8
Type the address of the TFTP server and press Enter.
The following message appears:
Enter Local Address [192.168.1.188]:
9
Type an IP address that can be used by the FortiGate unit to connect to the FTP
server.
The IP address can be any IP address that is valid for the network that the interface is
connected to. Make sure you do not enter the IP address of another device on this
network.
The following message appears:
Enter File Name [image.out]:
Enter the firmware image file name and press Enter.
The TFTP server uploads the firmware image file to the FortiGate unit and the
following message is displayed.
Save as Default firmware/Backup firmware/Run image without
saving:[D/B/R]
11
Type B.
The FortiGate unit saves the backup firmware image and restarts. When the FortiGate
unit restarts it is running the previously installed firmware version.
Switching to the backup firmware image
Use this procedure to switch the FortiGate unit to operating with a backup firmware
image that you previously installed. When you switch the FortiGate unit to the backup
firmware image, the FortiGate unit operates using the configuration that was saved
with that firmware image.
If you install a new backup image from a reboot, the configuration saved with this
firmware image is the factory default configuration. If you use the procedure
"Switching back to the default firmware image" on page 53
firmware image that was previously running as the default firmware image, the
configuration saved with this firmware image is restored.
To switch to the backup firmware image
1
Connect to the CLI using the null-modem cable and FortiGate console port.
01-28008-0013-20050204
System Status
to switch to a backup
Fortinet Inc.
Advertisement
Table of Contents
