Fortinet FortiGate FortiGate-5001 Administration Manual page 193

Router
FortiGate-5000 series Administration Guide
ospf-interface command keywords and variables (Continued)
Keywords and variables
mtu-ignore
{disable | enable}
network-type
{broadcast | non-
broadcast
| point-to-
multipoint
| point-to-point}
priority
<priority_integer>
retransmit-interval
<seconds_integer>
01-28008-0013-20050204
Description
Use this command to control
the way OSPF behaves when
the MTU in the sent and
received database description
packets does not match.
When mtu-ignore is
enabled, OSPF will stop
detecting mismatched MTUs
and go ahead and form an
adjacency.
When mtu-ignore is
disabled, OSPF will detect
mismatched MTUs and not
form an adjacency.
mtu-ignore should only be
enabled if it is not possible to
reconfigure the MTUs so that
they match.
Specify the type of network to
which the interface is
connected.
OSPF supports four different
types of network. This
command specifies the
behavior of the OSPF interface
according to the network type.
If you specify the non-
broadcast keyword, you
must also configure neighbors
using "config neighbor" on
page 187.
Set the router priority for this
interface.
Router priority is used during
the election of a designated
router (DR) and backup
designated router (BDR).
An interface with router priority
set to 0 can not be elected DR
or BDR. The interface with the
highest router priority wins the
election. If there is a tie for
router priority, router ID is
used.
Point-to-point networks do not
elect a DR or BDR; therefore,
this setting has no effect on a
point-to-point network.
The valid range for
priority_integer is 0 to
255.
The time, in seconds, to wait
before sending a LSA
retransmission. The value for
the retransmit interval must be
greater than the expected
round-trip delay for a packet.
The valid range for
seconds_integer is 1 to
65535.
CLI configuration
Default Availability
All models.
disable
broadcast All models.
All models.
1
All models.
5
193