L2Tp; L2Tp Range - Fortinet FortiGate FortiGate-5001 Administration Manual
Fortigate 5000 series
Hide thumbs
Also See for FortiGate FortiGate-5001:
- Quick start manual (2 pages) ,
- Introduction manual (77 pages) ,
- Quick manual (37 pages)
Table of Contents
Advertisement
VPN
L2TP
L2TP range
FortiGate-5000 series Administration Guide
Figure 139:PPTP range
Enable PPTP
You must add a user group before you can select the option.
Starting IP
Type the starting address in the range of reserved IP addresses.
Ending IP
Type the ending address in the range of reserved IP addresses.
User Group
Select the name of the PPTP user group that you defined.
Disable PPTP
Select the option to disable PPTP support.
A FortiGate unit can be configured to act as an L2TP network server. The FortiGate
implementation of L2TP enables a remote dialup client to establish an L2TP tunnel
with the FortiGate unit directly.
For information about how to perform the related tasks, see
procedures" on page
To enable L2TP and specify the L2TP address range
1
Go to VPN > L2TP > L2TP Range.
2
Enable L2TP and specify the address range.
The L2TP address range specifies the range of addresses reserved for remote clients.
When a remote client connects to the FortiGate unit, the client is assigned an IP
address from this range. Afterward, the FortiGate unit uses the assigned address to
communicate with the remote client.
Figure 140:L2TP range
Enable L2TP
You must add a user group before you can enable the option.
Starting IP
Type the starting address in the range of reserved IP addresses.
278.
01-28008-0013-20050204
L2TP
"L2TP configuration
271
Advertisement
Table of Contents
