Configuring Snmp - Fortinet FortiGate FortiGate-5001 Administration Manual
Fortigate 5000 series
Hide thumbs
Also See for FortiGate FortiGate-5001:
- Quick start manual (2 pages) ,
- Introduction manual (77 pages) ,
- Quick manual (37 pages)
Table of Contents
Advertisement
SNMP
Configuring SNMP
106
RFC support includes support for most of RFC 2665 (Ethernet-like MIB) and most of
RFC 1213 (MIB II) (for more information, see
This section describes:
•
Configuring SNMP
•
SNMP community
•
FortiGate MIBs
•
FortiGate traps
•
Fortinet MIB fields
Go to System > Config > SNMP v1/v2c to configure the SNMP agent.
Figure 39: Configuring SNMP
SNMP Agent
Enable the FortiGate SNMP agent.
Description
Enter descriptive information about the FortiGate unit. The description
can be up to 35 characters long.
Location
Enter the physical location of the FortiGate unit. The system location
description can be up to 35 characters long.
Contact
Enter the contact information for the person responsible for this FortiGate
unit. The contact information can be up to 35 characters long.
Apply
Save changes made to the description, location, and contact information.
Create New
Select Create New to add a new SNMP community.
Communities
The list of SNMP communities added to the FortiGate configuration. You
can add up to 3 communities.
Name
The name of the SNMP community.
Queries
The status of SNMP queries for each SNMP community. The query
status can be enabled or disabled.
Traps
The status of SNMP traps for each SNMP community. The trap status
can be enabled or disabled.
Enable
Select Enable to activate an SNMP community.
Delete icon
Select Delete to remove an SNMP community.
Edit/View icon
View or modify an SNMP community.
01-28008-0013-20050204
"FortiGate MIBs" on page
System Config
109).
Fortinet Inc.
Advertisement
Table of Contents
