NEC Express5800 Series Maintenance Manual page 93

Chapter 2 Useful Features
Option
Initiator IP Address
Initiator Subnet Mask
Initiator Gateway
Target DHCP Config
Target Name
Target IP Address
Target Port
Target Boot LUN
Authentication Type
CHAP Type
CHAP Use Name
CHAP Secret
Mutual CHAP User Name
Parameter
IP Address
IP Address
IP Address
(Check Box)
String of 4 to 223
alphanumeric characters
IP Address
1-65535
[3260]
[0]
CHAP
[None]
[One way]
Mutual
String of up to 126
characters
String of 12 to 16
alphanumeric characters
String of up to 126
characters
Express5800/R120h-1E, R120h-2E Maintenance Guide
Description
The IP address of the iSCSI initiator if not configured
via DHCP. The Initiator IP Address is always
auto-assigned if IP address type is IPv6. The address
can be IPv4 or IPv6, depending on the IP address
type.
The subnet mask of the iSCSI initiator if not
configured via DHCP. The address needs to be an
IPv4 or IPv6 address, depending on the IP address
type.
The gateway address of the iSCSI initiator if not
configured via DHCP. The address needs to be an
IPv4 or IPv6 address, depending on the IP address
type.
Enables or disables configuring the iSCSI target
settings from DHCP.(def:0)
The unique iSCSI Qualified Name (IQN) of the iSCSI
target, if not configured via DHCP. Only IQN format is
accepted. EUI format is not supported.
For example:
iqn.2015-02.com.nec:iscsitarget-iscsidisk-target.
The IP Address of the iSCSI target, if not configured
via DHCP. The address must be an IPv4 or IPv6
address, depending on the IP address type.
The iSCSI target TCP port number, if not configured
via DHCP. Valid port numbers range from 1-65535.
Typical iSCSI port numbers include 860 or 3260. If no
port number or any other number deemed invalid is
specified, the value 3260 will be used.
The iSCSI target Logical Unit Number (LUN), if not
obtained from DHCP. This value must follow the
SAM-2 spec. E.g. 0001-1234-5678-9ABC. If the
number is less than 5 characters, a dash character is
not required. E.g. 0001. If the lun number is 12345,
input 1234-5.
The iSCSI connection authentication method. This
can be None for no security or CHAP for Challenge
Handshake Authentication Protocol (CHAP).
The CHAP authentication type. When configured to
One way, the target authenticates the initiator. When
configured to Mutual, both the initiator and target
authenticate each other. This is applicable only when
the Authentication Method is set to CHAP.
The user name for CHAP authentication from the
initiator to the target. This is applicable only when the
Authentication Method is set to CHAP.
The password needed for CHAP authentication. Must
be between 12 and 16 characters long. This is
applicable only when the Authentication Method is
set to CHAP.
The user name for Mutual (reverse) CHAP
authentication (from the target to the initiator). This is
applicable only when the Authentication Method is
set to CHAP and the CHAP Type is set to Mutual.
1. System Utilities
93