Relocation And Storage - NEC Express5800 Series Maintenance Manual

Chapter 1 Maintenance
1.

Relocation and Storage

Follow the steps below if you want to relocate or store this server.
1. Remove the disc from the optical disk drive.
2. Power off the server (POWER LED goes off).
3. Unplug the power cord of the server from the power outlet.
4. Disconnect all the cables from the server.
5. Pack the server securely to protect from damage, shock, and vibration.
Be sure to observe the following precautions to use the server safety. Failure to
observe the precautions may cause death or serious injury. For details, see
Safety Precautions and Regulatory Notices.
 Do not disassemble, repair, or alter the server.
 Do not remove the lithium battery, NiMH, or Li-ion battery.
 Disconnect the power plug before installing or removing the server.
Be sure to observe the following precautions to use the server safely. Failure to
observe the precautions may cause burns, injury, and property damage. For
details, see Safety Precautions and Regulatory Notices.
 Make sure to complete installation.
 Do not get your fingers caught.
 Be careful of handling internal components that may be at high temperatures.
Note  If the server has hard disk drives, move the server while being careful not to
damage the drive.
 When storing the server, monitor the environmental conditions of the storage
area.
Temperature: 10C to 55C, Humidity: 20% to 80%
(No dew condensation is permitted)
Tips
Make backup copies of important data stored in the hard disk drive.
Important
If this server and internal optional devices are suddenly moved from a cold
place to a warm place, condensation will occur. Wait for a sufficient period of
time before using the server and other components.
Note
Check and adjust the system clock before operating after relocating or storing the
server.
Express5800/R120h-1E, R120h-2E Maintenance Guide
WARNING
CAUTION
1. Relocation and Storage
15