Control Panel And Indicators - Sanyo Denki SANUPS E11A Series Instruction Manual

Part Names
§ 5 . 2 C o
§ 5 . 2 C o
⑪
⑫
⑬
⑤
①
No. Label
① INPUT
② OUTPUT
③ ECONOMY
DOUBLE
④
CONVERSION
⑤ BATT.LOW
⑥
25
⑦
50
⑧ 75
⑨
100
⑩ O.L.
⑪ ALARM
INV.ON
⑫
STAND BY
INV.ON
⑬
STAND BY
BATT.TEST
⑭
⑮ BATT.TEST
⑯ CLEAR
Operation mode of the UPS and indication of LED
※1. Economy mode operation････When power conditions are good, UPS supplies this power to the load.
※2. Double Conversion Mode Operation････When power conditions fluctuate, UPS converts to the stable power, and
※3. Active Filter Mode operation････When the "Green DOUBLE CONVERSION" and the "Green ECONOMY" are
※4. For about 5 seconds after MAIN SW
as shown in the following table.
Output voltage setting
11
n t r o l P a n e l a n
n t r o l P a n e l a n
⑥ ⑦ ⑧ ⑨
② ③
④
Status display
UPS input power status
UPS output power status UPS outputting power supply
Operation mode
Operation mode
Battery status
Load level 25%
Load level 50%
Load level 75%
Load level 100%
Overload display
Failure status
Operation status
UPS ON/OFF switch
Battery test
Battery test operation
Stop buzzer, clear result of battery test
both off, the UPS is in Active Filter Mode.
is turned on, the LED that indicates the output voltage setting of UPS blinks
Blinking LED
100V Green LOAD LEVEL 25
110V Green LOAD LEVEL 50
115V Green LOAD LEVEL 75
120V Green LOAD LEVEL 100
d I n d i c a t o r s
d I n d i c a t o r s
⑭
⑮
⑯
⑩
Functions
Lit
Normal input
1
Economy mode operation ※
Double conversion mode
※ 2
operation
Battery power low
Load 25% or more
Load 50% or more
Load 75% or more
Load 100% or more
Load 105% or more
Serious failure detected
UPS outputting power supply
Result: Normal
supplies to the load.
For example, when the output voltage of the UPS is set
to 120V, after MAIN SW is turned on,
"Green LOAD LEVEL 100" blinks for about 5 seconds.
Indications of LED in this manual
The LEDs on the control panel are described as
"Green INPUT" or "Red ALARM".
The LEDs state are indicated as follows;
: LED lights.
Not lit
-
Input error
OFF
Power supply bypassing
OFF
3 -
※
OFF
※ 3 -
Battery power
Battery exhausted
normal
※ 4
Load under 25%
※ 4
Load under 50%
※ 4
Load under 75%
※ 4
Load under 100%
-
Load under 105%
-
No failure
OFF
Power supply bypassing
Testing
Blinking speed changes.
- ↓
Result: Error
: LED blinks.
Blink