Operating Procedures; Ups Startup - Sanyo Denki SANUPS E11A Series Instruction Manual

Operating Procedures

§ 1 1 . O
§ 1 1 . O
§ 1 1 . 1 U
§ 1 1 . 1 U
Proceed as follows to start up the UPS.
① Set
② Press and hold
Hold for 1 second.
Notes for the UPS operation mode and LED indicators.
After performing step ②, the "Green DOUBLE CONVERSION" lights regardless of the UPS operation
mode. And then the LEDs will be in the following state according to the operation of the UPS
depending on the "UPS operation mode" in the user setting.
The "Green ECONOMY" lights when the UPS is in Economy Mode.
The "Green DOUBLE CONVERSION" lights when the UPS is in Double Conversion Mode.
When the "Green DOUBLE CONVERSION" and the "Green ECONOMY" are both off, the UPS is in
Active Filter Mode.
27
p e r a t i n g P
p e r a t i n g
P S S t a r t u p
P S S t a r t u p
MAIN SW on the back panel of the UPS to "ON".
OUTPUT max.700W 10A
Set to "ON".
MAIN SW
EXT. EXT.
BATT BATT
r o c e d u r e
P r o c e d u r e
Indications of Switch and LED in this manual.
The switches or breakers are indicated by a frame
Example:
The LEDs on the control panel are described as
"Green INPUT" or "Red ALARM".
The LEDs state are indicated as follows;
INPUT
for at least 1 second.
s
s
MAIN SW .
: LED lights. : LED blinks.
Left figure shows rear view of E11A102.
When using E11A202 and 302,
operate .
MAIN MCCB
LEDs
LED that indicates the output voltage setting
of UPS blinks. (See §5.2 "Control panel and
Indicators").
↓ after 5 seconds
Green INPUT
Green INV.ON/STAND BY
Green OUTPUT
↓
Green INPUT
Green INV.ON/STAND BY
Green OUTPUT
Check that the "Green INPUT" stops
blinking and remains lit, and then
proceed to step ②.
Buzzer
Musical trill
LEDs
Green INPUT
Green INV.ON/STAND BY
Green OUTPUT
Green DOUBLE CONVERSION
After "Green DOUBLE CONVERSION"
lights, it might go off depending on the
input power condition or the load device
condition.
.
Blinking
Off
Off
Lit
Off
Off
Lit
Lit
Lit
Lit