Power-Up - JLG Toucan 8e Operation And Safety Manual

DTC FAULT MESSAGE
FUNCTION SELECTED BUT LIFT
0027
ENABLE SWITCH OPEN
DRIVE PREVENTED - TILTED &
0028
ELEVATED
RUNNING AT CREEP - MAX
0029
ELEVATION

2-1 Power-Up

DTC FAULT MESSAGE
POWER CYCLE
211
KEYSWITCH FAULTY
212
31210162
SECTION 6 – GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
DESCRIPTION
The Mast or the Jib joystick was activated, but the
enable switch was not.
Drive is prevented while the platform is not in
transport position and the chassis is not level.
Drive speed is limited while the mast if fully
extended.
Displays on the analyzer only.
DESCRIPTION
The normal help message is issued at each power
cycle. Displays on the analyzer only.
Both Platform and Ground Modes are selected
simultaneously. Defaults to Ground Mode.
– JLG Lift –
CHECK
• Release joystick and allow to center.
• Check if the joystick is obstructed or jammed.
• Check if the enable switch is damaged.
Refer problem to a qualified JLG mechanic.
• Check that the machine is tilted. If so, lower the plat-
form and reposition the machine to a level surface.
• Fully stow the platform.
• Check that the tilt sensor is securely mounted and its
wire connected.
Refer problem to a qualified JLG mechanic.
• Fully stow the platform.
• Check that the mast switches are securely mounted.
Refer problem to a qualified JLG mechanic.
CHECK
Normal operation. No check necessary.
Refer problem to a qualified JLG mechanic.
6-31