Table of Contents
Advertisement
4.8
ALARMS
Overload Warning Light/Alarm (if equipped)
When the maximum rated load in the platform is exceeded, RED
light indicators at both the ground and the platform control sta-
tions will blink and an audible alarm will sound. When the over-
load indicator warning is activated, all machine functions are
disabled. The platform must be safely unloaded until the alarm
stops.
Tilt Warning Light/Alarm
When the chassis is out of level (Refer to Table 6-1), the RED
light indicator at platform control station will illuminate. If the
mast is out of transport (stowed) position, and the chassis is out
of level an audible alarm will sound.
IF THE WARNING LIGHT IS ILLUMINATED WHEN THE MAST IS RAISED,
LOWER THE MAST AND REPOSITION MACHINE SO THAT IT IS LEVEL
BEFORE ELEVATING THE MAST.
When the tilt indicator warning is activated, the following func-
tions are affected:
-The Drive function is disabled out of stowed position.
31210162
-Mast/Jib Lift and Swinging movements switch to Creep
mode.
When the tilt indicator warning is activated, control the machine
as follows:
1. Lower the mast.
2. Return the platform in line with the chassis.
3. Lower the Jib.
4. Drive the machine to a smooth, firm and level surface.
AVOID RAISING THE MAST, OPERATING THE JIB OR SWINGING WITH
THE MAST RAISED WHEN THE MACHINE IS OUT OF LEVEL. ALWAYS
LOWER THE MAST AS MUCH AS POSSIBLE BEFORE OPERATING THE
JIB OR SWINGING.
– JLG Lift –
SECTION 4 – MACHINE OPERATION
4-11
Advertisement
Table of Contents
