JLG Toucan 8e Operation And Safety Manual page 109

DTC FAULT MESSAGE
FUNCTION PROBLEM -
229
TRIGGER PERMANENTLY
CLOSED
TRIGGER CLOSED TOO LONG
2210
WHILE IN NEUTRAL
FUNCTION ENABLE RELAY -
2233
INVALID SIGNAL
LIFT ENABLE SWITCH
2240
PERMANENTLY SELECTED
LIFT ENABLE SWITCH
2241
PERMANENTLY SELECTED
FUNCTION LOCKED OUT -
2242
MAST JOYSTICK NOT
CENTERED
FUNCTION LOCKED OUT - JIB
2243
JOYSTICK NOT CENTERED
GATE LIMIT SWITCH - FAULTY
2244
31210162
SECTION 6 – GENERAL SPECIFICATIONS & OPERATOR MAINTENANCE
DESCRIPTION
The trigger switch was closed during power-up in
platform mode.
The trigger switch was closed for more than
seven seconds while the joystick was centered.
There is a problem with the Function Enable Relay.
The Lift Enable Switch was closed during power-
up in platform mode.
The Lift Enable Switch was closed during power-
up in platform mode.
The Mast Joystick was not centered at power-up
in platform mode.
The Jib Joystick was not centered at power-up in
platform mode.
If equipped - A problem has been detected in this
function.
– JLG Lift –
CHECK
• Check if the trigger switch is obstructed or jammed.
Refer problem to a qualified JLG mechanic.
• Check if the trigger switch is obstructed or jammed.
Refer problem to a qualified JLG mechanic.
Refer problem to a qualified JLG mechanic.
• Check if the lift enable switch is obstructed or jammed.
Refer problem to a qualified JLG mechanic.
• Check if the lift enable switch is obstructed or jammed.
Refer problem to a qualified JLG mechanic.
• Release joystick and allow to center.
• Check if the joystick is obstructed or jammed.
Refer problem to a qualified JLG mechanic.
• Release joystick and allow to center.
• Check if the joystick is not obstructed or jammed.
Refer problem to a qualified JLG mechanic.
• Check if the Gate Limit Switches are damaged,
obstructed or jammed.
Refer problem to a qualified JLG mechanic.
6-33