Table of Contents
Advertisement
SECTION 3 – MACHINE CONTROLS AND INDICATORS
a.When lit, indicates that the controls are enabled. If a
function is not actuated within seven seconds, or a
seven seconds lapse between ending one function
and beginning the next function occurs, the enable
Green
light will go out and the enable must be released and
activated again to enable the controls.
When blinking, indicates that the machine is in a con-
figuration where the current activated function is not
permitted.
b.Indicates that the high drive cutout limit-speed is
engaged (the mast is out of transport (stowed) position).
Green
c.This light indicates that the control system has
detected an abnormal condition. This lamp when actu-
ated is flashing a DTC (Diagnostic Troubleshooting
Code). For an explanation of these codes and items,
Yellow
the operator can or cannot correct, see Section 6 Diag-
nostic Trouble Codes (DTC).
d.When the structure is swung beyond the rear tires or
further in either direction, the Drive Orientation indica-
tor will illuminate. This is a signal for the operator to
verify that the drive control is being operated in the
Yellow
proper direction (i.e. drive controls reversed situations).
e.Indicates that the chassis is out of level (refer to
machine specifications for max. allowable slope
angle). If the mast is out of the transport (stowed) posi-
tion and the chassis is out of level, an audible alarm
Red
will sound.
3-12
f. (If equipped) - Indicates that the maximum rated load
in the platform is exceeded. In addition to the warning
indicator, an audible alarm sounds. The platform must
be unloaded until the alarm stops.
Red
g.Indicates that a slack chain condition has been
detected. In addition to the warning indicator, an audi-
ble alarm will sound as long as the slack chain condi-
tion exists.
Red
h.This set of lights indicates the charge level of the bat-
tery.
i. (If equipped) - Indicates the Soft Touch frame is
against an obstacle. In addition to the warning indica-
tor, an audible alarm sounds. Once illuminated, only
the reverse movement to the one that caused the con-
Yellow
tact with the obstacle can be operated in Creep mode.
j. (XL Basket Only) - Indicates that one of the platform
gates is open.
– JLG Lift –
31210162
Advertisement
Table of Contents
