Removing the G8332 from a Lenovo iDataPlex Rack
1. Disconnect all external cables.
2.
If the 1U air‐duct option has been installed, remove it as described in "Removing
the Air‐Duct Option" on page
3. Loosen and remove the M6 washers, screws, and clip nuts that attach the alignment
plate.
4. Loosen and remove the M6 washers and screws that mount the switch into the
rack.
5. Slide the switch out of the rack.
© Copyright Lenovo 2017
This section describes how to remove the G8332 from a Lenovo iDataPlex rack.
To remove the G8332 from an iDataPlex rack, complete the following steps:
4
5
3
4
5
3
75.
7
Chapter 4: Removing and Replacing Components
73