Table of Contents
Advertisement
Removing the NE1032T from a Lenovo iDataPlex Rack
1. Disconnect all external cables.
2.
3. Loosen and remove the M6 washers, screws, and clip nuts that attach the alignment
4. Loosen and remove the M6 washers and screws that mount the switch into the
5. Slide the switch out of the rack.
72
NE1032T Installation Guide
This section describes how to remove the NE1032T from a Lenovo iDataPlex rack.
To remove the NE1032T from an iDataPlex rack, complete the following steps:
If the 1U air‐duct option has been installed, remove it as described in "Removing
the Air‐Duct Option" on page
plate.
4
5
3
rack.
4
5
3
74.
7
Hide quick links:
Advertisement
Table of Contents
