1. Locate, record, and retain the product switch information in order to configure and
2. Remove the rear cover screws:
3. Attach the front mounting brackets (Item 1) to each side of the switch with M4
42
G8332 Installation Guide
To install the G8332 in a System x or Power rack, complete the following steps:
register your product. See "Before Installing the G8332" on page
Note: If this switch is a replacement switch, copy the product information from the
original switch onto the RID label that is shipped with replacement switch and
affix the new label to the bottom of the new switch.
screws (Item 2). Torque the screws to approximately 2.0 newton‐meters (Nm) ± 0.1
Nm (17.7 inch‐pounds).
1
32.
1
6
2