Removing The Ne1064To From A Lenovo Idataplex Rack - Lenovo ThinkSystem NE1064TO RackSwitch Installation Manual

Removing the NE1064TO from a Lenovo iDataPlex Rack

1. Disconnect all external cables.
2. If the 1U air-duct option has been installed, remove it as described in
3. Loosen and remove the M6 washers, screws, and clip nuts that attach the alignment
4. Loosen and remove the M6 washers and screws that mount the switch into the
66
NE1064TO Installation Guide
This section describes how to remove the NE1064TO from a Lenovo iDataPlex rack.
To remove the NE1064TO from an iDataPlex rack, complete the following steps:
the Air-Duct Option" on page
plate.
4
3
rack.
4
3
68.
6
"Removing