1. Locate, record, and retain the product switch information in order to configure and
2. Remove the rear cover screws:
3. Attach front mounting brackets (Item 1) and rear mounting brackets (Item 6) to
4. From the front, slide the switch into the rack at the desired height.
46
G8332 Installation Guide
To install the G8332 in an iDataPlex rack, complete the following steps:
register your product. See "Before Installing the G8332" on page
Note: If this switch is a replacement switch, copy the product information from the
original switch onto the RID label that is shipped with replacement switch and
affix the new label to the bottom of the new switch.
each side of the switch with M4 screws (Item 2). Torque the screws to
approximately 2 newton‐meters (Nm) +/‐ 0.1 Nm (17.7 inch‐pounds).
32.
1
2
6