Removing the NE2580O from a Lenovo iDataPlex Rack
1. Disconnect all external cables.
2. If the 1U air-duct option has been installed, remove it as described in
3. Loosen and remove the M6 washers, screws, and clip nuts that attach the alignment
4. Loosen and remove the M6 washers and screws that mount the switch into the
66
NE2580O Installation Guide
This section describes how to remove the NE2580O from a Lenovo iDataPlex rack.
To remove the NE2580O from an iDataPlex rack, complete the following steps:
the Air-Duct Option" on page
plate.
4
3
rack.
4
3
68.
6
"Removing