Mitsubishi Electric PLK-G-CU-20 Technical Manual page 114

(4) Moving to designated stitch position
►Press
then,
►Press
.
(5) Moving to designated stitch position (B point)
►Move X-Y table to B point by pressing
►After move to the position, press
(6) Setting correction value
►Change material thicknes to [-1.6] by pressing up and down
arrow.
►After setting, press
(7)Finishing material step correction
►Press
to exit correction mode. Then screen is
changed to save mode. Press
saved, then screen is backed to standard screen.
(
If is pressed, pattern data is returned to former
state)
.
.
.
after data is
[11] - 44
.