Feed Angle - Mitsubishi Electric PLK-G-CU-20 Technical Manual

18.Feed angle

Function
S8
Setting for feed start angle
of clamp
E8
Setting for feed end angle
of clamp
S8C
Sets ON/OFF of the delay
supplement control of the
feed start angle.
E8C
Sets ON/OFF of the delay
supplement control of the
feed end angle.
S8S
Sets ON/OFF of the
separate feed angle
control for XY axis.
XS8
Setting for feed start angle
of X axis table
XE8
Setting for feed end angle
of X axis table.
XT8
Setting for feed start
supplement angle of X axis
table
YS8
Setting for feed start angle
of Y axis table
YE8
Setting for feed end angle
of Y axis table
YT8
Setting for feed start
supplement angle of Y axis
table
Unit Setting range
deg. 0 ~
E8
setting
value
deg. S8
setting
value
~ 356
Sets ON/OFF of the supplement control of the delay proportional at speed for the feed start
angle
- OF
ON
Sets ON/OFF of the supplement control of the delay proportional at speed for the feed end
angle
- OF
ON
Sets ON/OFF of the separate feed angle control for XY axis
- OF
ON
deg. 0 ~
XE8
setting
value
deg. XS8
setting
value
~ 356
deg. 0 ~
XE8
setting
value
deg. 0 ~
YE8
setting
value
deg. YS8
setting
value
~ 356
deg. 0 ~
YE8
setting
value
Sets the timing to start movement of the clamp during sewing
machine rotation. The setting indicates the angle from the down
position. This setting is validated when the FED setting is ID.
Sets the timing to end movement of the clamp during sewing
machine rotation. The setting indicates the angle from the down
position. This setting is validated when the FED setting is ID, IT.
The delay supplement control of the feed start angle(S8) is valid.
The delay supplement control of the feed start angle(S8) is
invalid.
The delay supplement control of the feed end angle(E8) is valid.
The delay supplement control of the feed end angle(E8) is
invalid.
The separate feed angle for XY axis is invalid
The separate feed angle for XY axis is valid
Sets the timing to start movement (S8) of X axis table during
sewing machine rotation. The setting indicates the angle from the
down position. This setting is validated when the FED setting is
ID.
Sets the timing to end movement (E8) of X axis table during
sewing machine rotation. The setting indicates the angle from the
down position. This setting is validated when the FED setting is
ID.
Sets the supplement timing to start movement (S8) of X axis table
during sewing machine rotation at high speed. The setting
indicates the angle from the down position. This setting is
validated when the FED setting is ID.
Sets the timing to start movement (S8) of Y axis table during
sewing machine rotation. The setting indicates the angle from the
down position. This setting is validated when the FED setting is
ID.
Sets the timing to end movement (E8) of Y axis table during
sewing machine rotation. The setting indicates the angle from the
down position. This setting is validated when the FED setting is
ID.
Sets the supplement timing to start movement (S8) of Y axis table
during sewing machine rotation at high speed. The setting
indicates the angle from the down position. This setting is
validated when the FED setting is ID.
[16] - 14
Specification