Mitsubishi Electric PLK-G-CU-20 Technical Manual page 60

Memo (A) It is for the combination data of a curve input and multiple (offset) sew.
The data like the figure below (right) is made as shown in the figure below (left) when curves which
pass point 2, point 3, and point 4 after an feed from the home position to point 1 are combined with
multiple sewing and inputs.(Distance=10mm and 2 times of "Frequency")
The distance of the multiple data becomes "It is narrow" the data as shown in figure.
They are not like to make this partially narrow multiple data, to make a constant distance multiple data
as much as possible, please input 2' between 2 and 3 as shown in the figure below (left). The multiple
data as shown in the figure below (right) is made.
Memo (B) It is for the combination data of a curve input (Broken line input) and multiple sew.
The data like the figure below (right) is made as shown in the figure below (left) when curves which
pass point 2, point 3, and point 4 after an feed from the home position to point 1 are combined with
multiple sewing and inputs.(Distance=8mm and 4 times of "Frequency")
The data is made in the curve that the fourth curve is different as understood from figure(right).
When the virtual input point which makes the multiple is requested by the operation, such a situation
like the figure below, the reason for it is to intersect in the multiple.
Moreover, such a situation changes variously depending on the condition of the input point etc. of
"Distance", "Frequency" of the multiple data, and the curve.
Please use a variety of trying.
[7] - 31