User-Specified Reread Delay
If you want to set your own length for the reread delay, scan the barcode below,
then set the delay (from 0-30,000 milliseconds) by scanning digits from the
Programming
2D Reread Delay
Sometimes 2D barcodes can take longer to read than other barcodes. If you wish to
set a separate Reread Delay for 2D barcodes, scan one of the programming codes
that follows. 2D Reread Delay Off indicates that the time set for
used for both 1D and 2D barcodes. Default = 2D Reread Delay Off.
Character Activation Mode
You may use a character sent from the host to trigger the scanner to begin
scanning. When the activation character is received, the scanner continues
scanning until either the
is received (see
40
Chart, then scanning Save.
* 2D Reread Delay Off
Medium (2000ms)
Extra Long (4000ms)
Deactivation
User-Specified Reread Delay
Character Activation
Character), or a barcode is transmitted. Scan the
Reread Delay
Short (1000ms)
Long (3000ms)
Timeout, the deactivation character
HF680 Series User Guide
is