Manual Trigger Mode; Led Illumination - Manual Trigger; Serial Trigger Mode; Read Time-Out - Honeywell Voyager 1450g Series User Manual

Manual Trigger Mode

When in manual trigger mode, the scanner scans until a bar code is read, or until the trigger is released. Default = Manual Trig-
ger-Normal.

LED Illumination - Manual Trigger

If you wish to set the illumination LED brightness, scan one of the bar codes below. This sets the LED illumination for the
scanner when the trigger is pressed. Default = High.
Note: This feature is not supported by the VG1450g2DHR.
Note: The LEDs are like a flash on a camera. The lower the ambient light in the room, the brighter the LEDs need to be so
the scanner can "see" the bar codes.
Low
Medium High

Serial Trigger Mode

You can activate the scanner either by pressing the trigger, or using a serial trigger command (see
10-3). When in serial mode, the scanner scans until a bar code has been read or until the deactivate command is sent. The
scanner can also be set to turn itself off after a specified time has elapsed (see

Read Time-Out

Use this selection to set a time-out (in milliseconds) of the scanner's trigger when using serial commands to trigger the
scanner. Once the scanner has timed out, you can activate the scanner either by pressing the trigger or using a serial trig-
ger command. After scanning the Read Time-Out bar code, set the time-out duration (from 0-300,000 milliseconds) by
scanning digits on the
* Manual Trigger - Normal
Programming Chart inside the back cover, then scanning Save. Default = 30,000 ms.
Read
Read Time-Out
Medium
* High
Trigger Commands
Time-Out, which follows).
on page
4 - 5