Note: The power supply must be ordered separately, if needed.
2. If you are connecting a CCB01-010BT Base, make sure the cables are secured in the wireways in the bottom of the
cordless base and the base sits flat on a horizontal surface.
3. The scanner beeps.
4. Verify the scanner or cordless base operation by scanning a bar code from the
manual.
The unit defaults to a USB PC Keyboard. Refer to
For additional USB programming and technical information, refer to "USB Application Note," available at
wellaidc.com.
Connecting with Keyboard Wedge
Note: This interface is not supported by the Voyager 1450g2DHR.
A scanner or cordless base can be connected between the keyboard and PC as a "keyboard wedge," where the scanner
provides data output that is similar to keyboard entries. The following is an example of a keyboard wedge connection:
1. Turn off power and disconnect the keyboard cable from the back of the terminal/computer.
2. Connect the appropriate interface cable to the device and to the terminal/computer.
1 - 2
CCB01-010BT Base
USB Connection:
page 2-3
for other USB terminal settings.
Sample Symbols
in the back of this
www.honey-