Paging; Paging Mode; Paging Pitch - Honeywell Voyager 1450g Series User Manual

Default = External or Interface Cable Power.
Base Charge Off
External Power Only

Paging

Paging Mode

By default, the paging button on the base or Access Point pages the scanners associated with that base or Access Point. If
you want the paging button on your base or Access Point to be disabled, scan the Paging Mode Off bar code, below.
When Paging Mode is off, the base or Access Point will no longer page scanners when the button is pressed. The red LED
on the base or blue LED on the Access Point will remain lit to indicate that Paging Mode is off. (This light will go out when
the button is pressed, then back on when it's released.) Default = Paging Mode On.
* Paging Mode On
Pitch
Paging
When you press the Page button on the base or Access Point, the scanners associated with that base or Access Point will
begin beeping (see Page Button
of the following bar codes. Default = Low.
* Low (1000 Hz)
on page 3-3). You can set the pitch of the paging beep for each scanner by scanning one
External or Interface Cable
Power
Paging Mode Off
Medium (3250 Hz)
3 - 7