Character Activation Mode; Activation Character - Honeywell Xenon 1900 User Manual

Medium (2000ms)
Extra Long (4000ms)

Character Activation Mode

You may use a character sent from the host to trigger the scanner to begin scanning. When the activation character is received,
the scanner continues scanning until either the
(see Deactivation Character
vation, then use Activation Character (following) to select the character you will send from the host to start scanning. Default =
Off.
* Off

Activation Character

This sets the character used to trigger scanning when using Character Activation Mode. On the
(Code Page 1252), page A-3, find the hex value that represents the character you want to use to trigger scanning. Scan
the following bar code, then use the
character. Scan Save to finish. Default = 12 [DC2].
Character Activation Timeout
on page 4-15), or a bar code is transmitted. Scan the following On bar code to use character acti-
Programming Chart
Activation Character
(page 4-14), the deactivation character is received
to read the alphanumeric combination that represents that ASCII
Short (1000ms)
Long (3000ms)
On
ASCII Conversion Chart
4 - 13