Extreme Networks BlackDiamond 10808 Installation Manual page 97

1 Attach the ESD-preventive wrist strap, that is provided, to your wrist and connect the metal end of
the wrist strap to the ground receptacle that is located on the top-left corner of the switch front
panel.
2 Use a #1 Phillips screwdriver to unscrew the two captive screws shown in
3 Simultaneously rotate the ejector/injector levers outward to disengage the module from the
backplane.
4 Grasp the module front panel with one hand, and place your other hand under the metal panel to
support the weight of the module.
5 Slide the module out of the chassis and place it immediately into an antistatic sack to protect it from
ESD damage and to prevent dust from collecting on the module's connectors.
6 If you are not going to install a replacement I/O module, cover the slot with a blank faceplate.
Otherwise, follow the I/O module installation procedure
To remove additional I/O modules, repeat steps 2 through 6.
You can install a blank front panel at any time, without causing disruption of network services.
Complete the action of installing a blank front panel in a reasonable time frame to avoid disruption to
adequate airflow.
You need the following tools and equipment to install a blank front panel:
ESD-preventive wrist strap
#2 Phillips screwdriver
Blank front panel
To install the blank front panel:
1 Select a slot for the blank front panel. Slots are numbered 1 through 8 and A or B in the
BlackDiamond 10K system chassis.
2 Attach an ESD-preventive wrist strap, that is provided, to your wrist and connect the metal end of
the wrist strap to the ground receptacle that is located on the top-left corner of the switch front
panel.
Figure 45.
on page 93.
97