Extreme Networks BlackDiamond 10808 Installation Manual page 74

Latches at top of closed cover
2 Remove the six screws that secure the cable guides to the mounting base.
3 Place the cable manager mounting base above the BlackDiamond 10K series switch chassis in the
rack.
4 Use six screws (not supplied) to mount the base onto the rack, as shown in
Center
screws
in first
5 Insert the center screw on each side first.
Before you tighten the center screw, you might need to adjust the height of the cable manager base
to ensure proper alignment with the other two screw holes. The distance between the chassis and the
cable manager base will be approximately 1/4-inch (6-mm) to 7/8-inch (20-mm).
Hinge tabs fit into cable manager base
Top view of open/removed cover
Figure
Center
screws
in first
EX_078
34.
EX_076
74