Extreme Networks BlackDiamond 10808 Installation Manual page 81

4 Place the ESD bag containing the MSM on a flat surface, clean from any debris.
5 Break any seals on the bag.
6 Open the ESD bag and firmly grasp the rail of the module.
7 Holding the rail of the module, pull the ESD bag off the module.
8 Check the connectors for dust and packing materials.
9 Ensure that the MSM is vertical as shown in
Module name at the top
PCB to the right
Ejector/injector levers extended
10 Slide the MSM into the appropriate lettered slot of the chassis, until it makes contact with the
backplane.
As the MSM begins to seat in the chassis, the ejector/injector levers begin to close.
Figure 39, with the:
Module status LEDs
Module reset button
Management port
Console port
Compact flash
EX_016
81