Msm Module - Extreme Networks BlackDiamond 10808 Installation Manual

This section describes:
Installing the MSM
Verifying the MSM Installation
Removing an MSM
The BlackDiamond 10K series switch comes with eight blank front panels already installed. Use a blank
front panel to fill slots not occupied by I/O modules or switch management modules. For information
about how to install a blank front panel, see
The BlackDiamond 10K series MSM is hot-swappable. You can insert a BlackDiamond 10K series MSM
at any time, without causing disruption of network services. Complete the action of inserting a
BlackDiamond 10K series MSM in a reasonable time frame. Be sure to insert the module completely to
avoid partial connection of backplane connectors.
You need the following tools and equipment to install an MSM:
Electrostatic discharge (ESD)-preventive wrist strap (provided)
# 1 Phillips screwdriver

MSM module

To install the MSM:
1 Select a slot for the module:
Slot A or slot B in the BlackDiamond 10K system chassis
2 Attach the ESD-preventive wrist strap to your wrist and connect the metal end of the wrist strap to
the ground receptacle that is located on the top-left corner of the switch front panel.
3 Remove the blank faceplate from the slot to make room for the module, if applicable.
clear log static
"Installing a Blank Front Panel" on page
clear log static
97.
80