Extreme Networks BlackDiamond 10808 Installation Manual page 159

5 Hold the module by its sides and insert it into one of the two slots on the Summit XGM-2xn
(Figure 96).
6 Slide the XENPAK module as far into the slot as possible, until you hear it click, indicating that it is
firmly attached.
7 Secure the XENPAK module to the Summit XGM-2xn card by turning the captive screws clockwise
until they are hand-tight.
8 Store the antistatic container, dust covers, and card-edge connector protective pad in a clean location
in case you need to remove the XENPAK module.
9 Remove the dust covers from the module connectors before you connect cables.
10 If only one XENPAK module is installed, attach a supplied cover plate over the other module slot.
To remove a XENPAK module:
1 Disconnect the AC power and any redundant power supply from the switch.
2 Attach an ESD-preventive wrist strap to your wrist and connect the metal end of the wrist strap to
the ground receptacle that is located on the top-left corner of the switch front panel.
3 Disconnect the fiber-optic cable from the XENPAK module and install dust covers over the module
connectors.
XENPAK Module
Cover Plate
ES4K043A
159