Extreme Networks BlackDiamond 10808 Installation Manual page 157

To install the Summit XGM-2xn card:
1 Disconnect the AC power and any redundant power supply from the Summit switch.
2 Attach the ESD-preventive wrist strap to your wrist and connect the metal end of the wrist strap to
the ground receptacle that is located on the top-left corner of the switch front panel.
3 Using a number 1 Phillips screwdriver, remove the filler panel from the option slot on the back of
the switch (Figure 93). Save the screws for re-use.
4 Align the edges of the sheet metal with the card guides, and carefully slide the Summit XGM-2xn
card into the switch housing until the connectors engage and the card is flush with the back panel of
the switch (Figure 94).
5 Using the screws from the cover plate, secure the Summit XGM-2xn card to the back panel of the
switch.
Filler Panel
Summit Option
Card
ES4K041
ES4K042
157