Extreme Networks BlackDiamond 10808 Installation Manual page 166

To remove an EPS-160 power supply from an EPS-T:
1 Attach an ESD-preventive wrist strap to your wrist and connect the metal end of the wrist strap to
the ground receptacle that is located on the top-left corner of the switch front panel.
2 Disconnect the AC by removing the plug from the wall
3 Disconnect the AC power cord from the EPS-160 power supply.
4 Remove the redundant power cable from the EPS-160 supply.
5 Loosen the thumbscrews on the front of the tray and slide the EPS-160 power supply out of the
EPS-T.
166