Extreme Networks BlackDiamond 10808 Installation Manual page 132

8 Verify that the red line of each captive screw in both injector/ejector handles is set in a vertical
position. This position ensures that the module is locked as shown in
9 Store the module packaging for future use.
This section describes important safety information and correct procedures for removing a
BlackDiamond 8810 MSM or I/O module. All BlackDiamond 8810 modules are hot-swappable. You do
not need to power the system off to remove a BlackDiamond 8810 module.
Follow these steps to ensure proper removal of an MSM or I/O module:
1 Attach the ESD-preventive wrist strap, that is provided, to your wrist and connect the metal end of
the ESD-preventive wrist strap to the ground receptacle that is located on the top-left corner of the
BlackDiamond 8810 chassis.
2 Unlock the module by turning each captive screw back one-quarter turn counter-clockwise (90
degrees) in both injector/ejector handles. Use a # 2 Phillips screwdriver.
3 Verify that the red line of each captive screw in both injector/ejector handles is set in a horizontal
position. This position ensures that the module is unlocked as shown in
Figure 73.
ASP004
Figure 74.
132