Extreme Networks BlackDiamond 10808 Installation Manual page 130

Follow these steps to ensure proper installation of an MSM or I/O module:
1 Attach the ESD-preventive wrist strap, that is provided, to your wrist and connect the metal end of
the ESD-preventive wrist strap to the ground receptacle that is located on the top-left corner of the
chassis.
2 Remove the blank front panel if applicable.
3 Pull the ESD bag off of the module:
a Place the ESD bag containing the module on a flat ESD surface, clean from any debris.
b Break the quality seal and the ESD warning seal.
c Open the ESD bag and firmly grasp the rail of the module.
d Pull the ESD bag off while holding the rail of the module.
4 Before inserting the module, ensure that the module injector/ejector handles are open as shown in
Figure 70.
5 Slide the module into the slot using the injector/ejector handles in the open position.
ASP001
130